How often do you need to clean your beer lines?

At a minimum you should clean your tap lines once every 4-6 weeks. Our recommendation is to clean and sanitize your beer or wine tap lines between each keg you serve on your draft system to make life easier.

What happens if you don’t clean beer lines?

Bacteria and wild yeast growing in the beer line will spoil the aroma and flavour of the beer. You wouldn’t serve a customer food on a plate that hadn’t been cleaned for two weeks, so why would you serve them beer through lines that had not been cleaned for two weeks.

How often should you clean the lines in a pub?

Clean every four weeks​ Pubs could clean their lines up to every four weeks and still meet the hygiene standards of a good quality, clean pint, furthered Thomson.

What is the best beer line cleaner?

As for the cleaner you choose, OxiClean works well as long as you don’t allow the lines to sit empty between kegs. If you plan to tap a new keg right after emptying the old one, then flushing with OxiClean and rinsing with hot water is probably sufficient.

You might be interested:  Often asked: What Color Is Root Beer?

Can you leave water in beer lines?

Do not leave water in beer lines, empty keg lines by blowing and pulling water through until just air remains or fill lines with a protector. All couplers should be sanitised and attached to ring main sockets. Remove hop filters from cask lines and hang the lines off the floor.

Can you get sick from dirty beer lines?

Bacteria, yeast, mold, and beer stone will build up and quickly degrade the quality of draft beer. Having bacteria in the beer lines can send you running for the toilet. Although you are not likely to get salmonella poisoning or the Hantavirus by drinking beer served through dirty lines, it is still nasty business.

Can I clean beer lines with bleach?

Chlorine bleach is ok to use as long as it does not have any added scents. The main thing to remember is to rinse, rinse, rinse. Any traces of bleach will end up contaminating your brews.

Is beer line cleaner toxic?

An example of a good quality beer line cleaner is Proton Protinate. It is a concentrated solution of Sodium Hydroxide and Sodium Hypochlorite. If allowed to come into contact with the skin or other soft tissues it could cause severe burns and it is highly poisonous.

What problems are caused by dirty beer lines?

A beer that’s been through unclean draft lines or taps may have a slightly sour, vinegary flavor due to acetic acid, and a buttery flavor from a chemical called diacetyl (the very same used to flavor microwavable popcorn).

You might be interested:  Often asked: How To Make An Airplane Out Of Beer Cans?

How long can you leave beer line cleaner in the lines?

To be safe and not run the risk of damaging your beer lines through over exposure to the cleaning fluid, you should leave them in soak to a maximum of 45 minutes.

Can you clean beer lines with vinegar?

White vinegar is absolutely OK to sanitize the brew equipment. I use it all the time. And I can buy it for less than a dollar a gallon. Just swish and spray every thing and completely drain it.

Can you use baking soda to clean beer lines?

Member. Soak with white vinegar (dissolves buildup of minerals and sludge) then rinse with water or water & bicarbonate ( baking soda ) mixture.

Do you need to clean new beer lines?

It is recommended that you clean your draft lines with caustic beer line cleaning solution a minimum every two weeks or, at least, every time you change kegs.

Leave a Reply

Your email address will not be published. Required fields are marked *